(May 8, 2010)
not done with plumbing…but very close, last part i have to order a few items, should be done next week
pictures were resized on upload, text hard to read, dont try to to them, just read under the picture
rock
marco & bulk reef supply rocks, 3/4″ acrylic rods, 1/2″ hdpe with 3/4″ holes drilled, 1/4″ hdpe for bottom layer, 48″ L x 15″ W
workbench
2x4basics workbench, utility sink is model 14c, little giant ladder, sink is fed from kitchen using murlok and tube connections (cold connections)
rodi
5 stage ro/di from bulk reef supply, 2 44 gallon brutes, 2 10 gallon brutes, 100 gallon rubbermaid stock tank
insullation
1″ foamular 150 insulation, cover for sump & under sump
A = 1.5″ drain into 2″ to 1.5″ reducer, not glued, if sump falls, wont drag down aquarium
B = 2″ cap, will drill small holes for tubing. tubing will include freshwater for evaporation
C = 4 port clear pvc manifold (flexpvc.com), 2″ in and out, 4 3/4″ outputs (recirc, drain, not sure after that)
pump
poseidon ps3 pump, very quite (no fan, water cooled), 2x4basics shelf, came with workbench
sump
1.5″ drain x 2, 3/4″ return, return valve, swc 160 cone
sump cover
cover for sump, small area scrapped out for power cords so it sits flat, protein skimmer holes